Overview
UHP water cleaning machine uses higher water pressure from 1,000 bar to 3,000 bar or higher . Which requires a special high pressure water pump and hydraulic and control systems.
UHP water jet cleaning can also successfully deburring edges . And holes post casting or machining processes on all kinds of non-steel metals.
UHP hydroblasting is method of cleaning sewer. Drain lines using high pressure water with big flow rate can be up to more than 320L/min .
An engine or motor drive a high pressure water pump that produces ultra high water can go up to 500 bar for sewer cleaning. And more than 2800bar for surface preparation.
All UHP water jet cleaning is rated as to pump’s pressure and flow rate. both a direct result of the available engine’s horsepower.
Wide range UHP water cleaning machine
Watex offers a wide range UHP water cleaning machine positive displacement plunger pumps . And UHP hydroblasting machine for heavy duty cleaning . Full range of accessories, options of diesel engine or electric motor drive. trailer or skid mounted to suit any specific requirements of high pressure pumps . UHP water jet cleaning machine is mainly used in the petro-chemical, offshore and contracting industries.
Water from the high pressure pump is delivered to a hose reel containing high pressure jetting hose matched for the pressure and flow .
When a nozzle is attached to the end of the jetting hose, pressure is created within the system. Nozzles are sized to match the design out of the engine .And water pump plus factoring pressure loss due the diameter and length of the high pressure jetting hose.
Every nozzle is designed to direct high pressure streams of water to pull the high pressure jetting through a pipe.
Angles of the water stream can be varied; water streams directed more toward the pipe wall surfaces . Produce better cleaning results while diminishing the pulling power of the nozzle.
Water streams directed towards the centerline of the pipe provide maximum pulling power but decreases pipe wall cleaning effectiveness.
Rotative head for the UHP water jet cleaning
To clear the clogged sewer line or drainage, a nozzle with a rotative head is used. UHP water cleaning machine can meet you requirement and cleaning tasks.
Forward jet only use a small proportion of the total LPM to bore through a blockage with a minimal loss of propulsion.
The forward jet is design to bore into the blockage to allow the rear jets with more flow to remove the bulk or remainder of the blockage.
During the working ,the forward jet may have reduced flow per orifice compared to the rear nozzle orifices; the pressure is always the same at all orifices.
